Mise à niveau VORTRIXE Moteur à essence entièrement métallique Hit & Miss Moteur à combustion interne

VORTRIXE & OKMO M90 Full Metal Upgrade Hit & Miss Gas Engine IC Engine

Features:

- A hit-and-miss engine is a type of four-stroke internal combustion engine that is controlled by a governor to operate at a set speed.

- This is an upgraded hit-and-miss engine, equipped with a wooden base for easy placement and operation.

Engine Startup Steps:

1. Open the bottom of the base to check the wiring of the engine, connect the fuel tank pipe, and install 3 AA batteries.

2. Fill the fuel tank with 95# gasoline. After filling, ensure there is no air in the fuel pipe.

3. On the right side of the engine (installation of the flying hammer position), slowly turn the flywheel counterclockwise by hand more than one turn. This allows the mixed gasoline to fully enter the cylinder.

4. Turn on the power switch and rotate the flywheel counterclockwise on the right side of the engine (flying hammer position) to start the engine.

Precautions:

1. If the ignition device is normal and the cylinder has normal compression but the engine does not start, the carburetor needle may need adjustment.

2. Screw the top screw on the carburetor, then loosen 1/4 turn and start the flywheel. Repeat if necessary to achieve the normal gasoline-to-air mixture ratio.

Note:

1. Due to different displays and lighting, the picture may not reflect the actual color of the item.

2. Please allow slight differences due to manual measurement.

3. Children should be accompanied by an adult.

4. Be careful when adding fuel.

5. The O-ring may not be completely airtight; this can help the engine start more easily.